Paintball Gear Operation Guides and Manuals

Apply 5-7 drops of lubricating oil into the end of the marker body
Install the Co2 cylinder into the end of the marker body
Press the button on the "Butt Stock's Locating Sheet" and insert it into the hole named "Locating Hole"
Pull down the "Stock Release Lever" and slide onto the end of the marker body
Turn the Co2 cylinder knob on (counter-clockwise)
Note: for 30g Co2 cylinder, turn cylinder on before installing "Butt Stock"

Paintball Loading Procedures

Twist the switch (clockwise) on the side of the "M4 Magazine" until tight
Open Paintball package and flip the lip up inside the package
Insert paintballs into the "M4 Magazine" with the open side facing forward - follow instruction on the lid

Shooting Procedures

Shooting Procedures.jpg

Insert "M4 Magazine" from the bottom of the marker
Pull back cocking handle to open "Cartridge Ejection Opening"
Switch the "Safety Catch" to "SEMI" for single shot and "AUTO" for full auto
Aim and pull the trigger

Adjusting Shooting Velocity

Push out rear "Locking Pin"
Flip up top of the marker body
Use provided tool to adjust shooting velocity (Counter-clockwise for faster shooting velocity and clockwise for slower shooting velocity

Barrel Disassembling Procedures:

Disassembling Barrel

Disassembling Barrel.jpg

Push out the two "Locking Pins" and separate upper and lower Body parts
Pull down "Fore Grip Ring" and pull out upper and lower "Fore Grip"
Turn and release "Fore Grip Ring"
Unscrew "Barrel Locking Ring" to loosen the Barrel (covered by the "Fore Grip Ring")
Pull out the barrel

Cleaning Barrel

Cleaning Barrel Procedures.jpg

Press the "Magazine Catch Button" to release the magazine
Pass one end of the "Cleaning Wire" through the "Cartridge
Ejection Opening" to the "Barrel Muzzle" and attach the "Cleaning Cloth" at the other end of the "Cleaning Line"
Pull the "Cleaning Wire" from the "Barrel Muzzle" slowly
Repeat this procedure with a clean "Cleaning Cloth" a few times if necessary

Push out the two "Locking Pins"
Separate the "Upper Marker Body"
Use water to clean the barrel
After drying the barrel, Hold the "Cartridge Case Rod" and put the "Upper Marker Body" back on
Put the two "Locking Pins" in
Note: make sure to dry the barrel completely after washing

Core Disassembling Procedures

Core Disassembling

Core Disassembling.jpg

Disassembling Hand Grip

Disassembling Magazine Catch System

Disassembling Magazine Catch System.jpg

Disassembling Safety Catch System

Separate Safety Catch.jpg

Unscrew the "Safety Catch Fixing Screw" on the left hand side of the marker body
Pull out the "Safety Catch"
Pull out the "Locking Pin" on the other side of the marker body

Sale News